Let's take a look at the mushroom plate and the traditional floor heating in the end what is the difference between the construction?

1. Comparison between traditional floor heating and mushroom plate: tube spacing

The size of the pipe spacing determines the heating effect of the floor heating to a certain extent. The traditional floor heating depends on the grid on the reflective film to determine the spacing between the floor heating pipes, which is greatly influenced by the construction personnel and is difficult to be uniform.

Mushroom plate just solves the influence of human factors. The floor heating pipe is embedded in the module, and the standard construction of 5cm pipe spacing makes the construction standardized and controllable.

2. Comparison between traditional floor heating and mushroom plate: tube fixation

In the traditional floor heating construction, 35-45 staples are used for one square meter, and more staples are used at turning corners, which destroys the integrity of the insulation layer, and concrete moisture may stay in the stapling holes.

However, the edge of the mushroom head is equipped with a 3mm barb, which does not need additional staples to fix, effectively prevents the pipeline from falling off, and the thermal insulation layer is complete and more energy-saving.

3. Comparison between traditional floor heating and mushroom plate: dead fold

Dead folding is a possible situation in floor heating construction. The dead folding of the pipeline will lead to poor water flow, large water resistance, and even blockage of the pipeline.

The existence of the mushroom head ensures good control of the pipe spacing and avoids dead pipe folding.

4. Comparison between traditional floor heating and mushroom plate: installation

The larger the contact area between the floor heating pipe and the concrete heat storage layer, the better the heat dissipation effect and the more energy saving.

In the traditional floor heating construction, the general floor heating pipe is in direct contact with the insulation board, and it is difficult to do 360 ° suspension installation. The wire mesh has a certain effect of lifting the pipe, but it cannot be completely lifted. If this is achieved by reducing the spacing of the wire mesh, the cost will be much higher.

Mushroom plate can realize suspension installation, and the edge on the module makes the pipeline lifted and contacted with concrete 360 ° after backfilling. Speeding up heat dissipation also makes it easier and more energy-efficient to heat up.

5. Comparison between traditional floor heating and mushroom plate: protecting pipelines

Backfill layer construction is required to cover construction, so as not to damage the pipeline. The pipe in the mushroom plate is embedded in the middle of the mushroom head, which can better protect the pipe.

6. Comparison between traditional floor heating and mushroom plate: splicing method

The integrity of the insulation layer directly determines the energy saving of floor heating, and household heating without insulation is equal to high usage fees. Traditional floor heating extruded plate gap and reflective film gap generally use special aluminum foil tape.

The mushroom board adopts buckle groove, seamless splicing, simple, convenient and effective.

7. Comparison between traditional floor heating and mushroom plate: construction efficiency

The traditional floor heating construction steps are complicated. It takes 7 steps from the edge strip to the silicon crystal net. The manual requirements are high and the construction results are difficult to control. It is entirely determined by the quality of construction personnel.

The mushroom board only needs 3 steps, the single layout is large, the working hours are saved, and the construction is standardized.